Hi folks ! Been a while since the last update… This weekend I was pretty busy on the print side, I succeed to print all the part composing the lower body. The design is not yet perfect but it’s working well for now 😉 As you can see below, the body is divided in 5 pieces maintained together with screws.
The battery is integrated and connected, as well as the board’s support. The ATXRaspi, the IR telemeter and the LED board are also mounted and connected 😉 The next step now is to connect properly the Li-Ion Charger, the Power Board and the Audio Amplifier, before assembly the upper body !
As you can see, for now it’s a bit messy with all the cables, but I will try to organise it better in the next few days 😉 Anyway, I’m very happy to finally assembling Animabot after so much time of design !!!
Stay tuned 😉
Great stuff! You must be so excited to be at this point. Looks really great. Can’t wait to see it fully assembled.
Thanks ! Yes I am 🙂 I will print the upper body in the next few days to continue the assembly